A PCB Design Potpourri


Reading time ( words)

In this column, I will be revisiting topics covered in some of my older columns and fleshing them out with new, updated information. In this job, I truly learn something every day, and I’m happy to share a few notable nuggets with you.

The Quote Process

Ultimately, whether it’s a quick-turn or standard lead-time job, customers would like to see all quotes back within a couple of hours, not a couple of days. Additionally, they want to see accurate quotes that take into account all additional processes. It’s never good when, once quoted, the fabricator comes back with additional costs for unforeseen processes. Again, this is why it is important to get a manufacturing review done if anything outside the norm is required on the drawing or quote. This includes a proper review of impedances to ensure that materials are available and the impedances work without requiring large variances in dielectric or line sizes, buy-offs for any deviations of material type or copper weights, etc.

Beyond the quote process, be sure that your fabricator is capable of all the processes necessary to ensure the board is built as expected. You want your board shop to be IPC-6012 Class 3 capable and ISO certified, and perhaps ITAR as well. Even if you can’t visit the shop for a physical qualification, send them a job to quote and see how they respond. A good fabricator will be diligent and get back to you within a few hours after completing a preliminary examination of the files, impedance calculations and proposed stackup if the board is impedance/dielectrically controlled. They should also be able to let you know right away if the job does not meet their process minimums and can’t be built. If deviations are allowed, a good fabricator will also have an alternative for many situations, such as a deviation for material type, starting copper weight, dielectrics or line sizes to be able to produce the job.

Read the full column here.


Editor's Note: This column originally appeared in the July 2013 issue of The PCB Design Magazine.

Share

Print


Suggested Items

The Quest for Perfect Design Data Packages

01/18/2019 | Barry Matties, I-Connect007
There’s an ongoing problem in the PCB industry: fabrication shops are receiving incomplete or inadequate design data packages, leaving manufacturers scrambling to fill in the blanks. For a quick-turn prototype shop like Washington-based Prototron, with over 5,000 customers and up to 60% of orders coming from new customers each month, that can add up to a lot of wasted time and effort just in the quoting stage. Dave Ryder, Prototron president, and Mark Thompson, engineering support, delve into this continuing issue and more.

A Fractal Conversation with Jim Howard and Greg Lucas

01/15/2019 | Barry Matties and Andy Shaughnessy, I-Connect007
Veteran PCB technologists Jim Howard and Greg Lucas have made an interesting discovery: Certain shapes of copper planes make a PCB run more efficiently than other shapes, a process they dubbed fractal design. It doesn’t appear to cost a penny more, and testing suggests that fractal design techniques could eliminate edge noise. Barry Matties and Andy Shaughnessy asked Jim and Greg to discuss the fractal design process, and the advantages of using this technique.

Calculation of Frequency-Dependent Effective Roughness Dielectric Parameters for Copper Foil Using Equivalent Capacitance Models

01/02/2019 | Marina Y. Koledintseva, Metamagnetics Inc.*, and Tracey Vincent, CST of America
Knowledge of the correct parameters of laminate PCB dielectrics refined from any copper foil roughness impact and the proper foil roughness characterization are important constituents of modeling high-speed digital electronics designs.



Copyright © 2019 I-Connect007. All rights reserved.